Avery Dennison Monarch 9416 XL Quick Reference - Manual (Page 13)

13
7. Insert the ends of the supply holder into the slots in the supply
roll mount.
IMPORTANT: Make sure the plastic line attaching the supply
holder to the printer is tucked down out of the way of
the supply holder and supply holder guides.
Otherwise, the plastic line may wrap around the
supply holder or get caught on the supply holder
guides.
8. Adjust the supply guides to their widest position.
9. Remove the first two labels from the backing paper.
10. For thermal direct printers, feed the labels, printing side up,
under the supply guides and over the platen roller.
For thermal transfer printers, feed the labels, printing side
up, under the white roller, under the supply guides, and
over the platen roller.
11. Press the labels under the supply guides.
12. Move the supply guides so that they barely touch the edges of
the backing paper.
13. Feed the backing paper under the peel roller and through the
peel door opening.
14. Push the peel door closed and close the cover or supply door
until it locks in place.
For thermal transfer printers, close the supply door by
lifting the supply door slightly and pulling the bottom of the
supply door support forward towards the front of the
printer. Close the supply door slowly and make sure it
latches securely.
Note: If you do not latch the cover or supply door completely,
poor print quality may result.
Peel Roller Peel Door
Peel Bar