beautypg.com

Adjusting the print position -3, Supply position -3, Print margin -3 – Avery Dennison Pathfinder 6057 Operator Handbook User Manual

Page 23: Overfeed distance -3, Max supply length -3

background image

A d j u s t i n g t h e P r i n t P o s i t i o n

1. Turn on the printer.

2. Touch the Home key.

3. Select Printer Config and then Print Position.

4. Touch the left or right arrows to increase or decrease the Supply Position, Print Margin,

Overfeed Distance, and/or Max Supply Length.

5. Touch OK when finished.

Supply Position

Adjust the supply position to set where data prints vertically on the supply. The adjustments are
in steps (0.00333 inch). The default value is 0. Increase the number to move the supply closer
to the chute; decrease the number to move the supply away from the chute.

Print Margin

Adjust the print margin to set where data prints horizontally on the supply. The adjustments are
made in dots (0.0049 inch). The range is -99 – 99, the default value is 0. Increase the margin
position to move print to the right, decrease to move print to the left.

Overfeed Distance

Adjust the overfeed distance to set the distance that your supply is fed out of the chute after it
prints. The adjustments are in steps (0.00333 inch). The default value is 0. Increase the
number to feed more supply out of the chute; decrease the number to feed less supply out of
the chute.

Max Supply Length

Adjust the Max Supply Length if you are using supply that is longer than 8.0”. The size of your
supply is measured from top to bottom. The default value is 8. If your supply is shorter than 8”
you do not need to adjust this setting (the printer automatically detects supply that is 8” or
shorter).

Configuring the Printer 4-3

This manual is related to the following products: