Avalon Firestyles DVS Insert-1996 to 2000 - Manual (Page 14)

P AGE 14
F
INALIZING THE
I
NSTALLATION - For Qualified Installers Only!
! Turn the gas control valve to "OFF" prior to conducting any service.
1 Follow the instructions below to remove the glass.
Cross Section of
Glass Attachment
Glass
Glass Gasket
(3/4" self-adhesive
channel gasket)
Glass Clip
Glass Clip
Attachment Studs
Face of Heater
Glass Clip Nuts
Loosen the nuts on the
top and side glass clips
until they are flush with
the end of the stud (do
not remove the nuts).
a
3/8" Nutdriver
b
While holding the glass,
loosen the nuts on the
bottom glass clip until
they are flush with the
end of the stud. Pivot
the glass forward and
remove.
Tighten the nuts on the
bottom glass clip first, then
the top, then the sides.
Removing the Glass
While holding the glass, slide the
side and top glass clips off.
c
Replacing the Glass
With the bottom glass clip in place and
the nuts flush with the end of the stud,
position the glass over the bottom clip
(do not tighten the nuts).
Replace the top glass clip
(do not tighten nuts).
Center the glass then
replace the side glass clips
(do not tighten nuts).
a
b
c
d