Nsert, Nstallation, Manifold removal – Avalon Firestyles DVS Insert-1996 to 2000 User Manual
Page 13: Electrical connection

I
NSERT
I
NSTALLATION
(C
ONT
.)
- For Qualified Installers Only!
P
AGE
13
MANIFOLD REMOVAL:
1
Remove the glass (see the instructions on page 14).
2
Remove the four bolts inside the firebox that hold the manifold to the exhaust ducts.
3
Remove the three screws holding the convection top to the insert.
NOTE: When replacing the manifold, use the convection top to guide the manifold. You may also
reach through the exhaust ducts to guide the manifold forward to the appropriate location.
Remove the four bolts
inside the firebox.
7/16Ó
Socket
5/16" Nutdriver
Remove the three screws holding
the convection top to the insert.
Convection Top
Manifold
Slide the
manifold
back.
NOTE: when installing the
manifold, make sure the
gaskets sealing the inlet and
exhaust ducts are in place. If
a gasket is loose, use high-
temperature silicone to
secure it to the manifold.
Shim the manifold legs if
installing into a fireplace
with a raised hearth.
Electrical Connection
¥
Plug the power cord into a grounded 120 Volt outlet (do not remove the grounding plug).