Avalon Firestyles DVS Insert-1996 to 2000 - Manual (Page 12)

P AGE 12
I
NSERT
I
NSTALLATION
(
CONT
.)
- For Qualified Installers Only!
Surround Panel Installation (continued)
3 Install the on/off switch following the directions below.
Upper
Right
of Trim
Keep the jumper wire in
place while installing.
Disconnect the on/off switch from the red and brown
wires leading from the heater. Insert the switch into
the hole in the upper right of the panel trim until it locks
in place. Re-attach the red and brown wires
(orientation does not matter).
Manifold Removal and Installation
¥ The manifold is shipped attached to the insert, but may be removed to facilitate especially tight
installations. See the directions below for installation.
1 Remove the manifold and place it within the fireplace (see the instructions on the following page).
2 Route the flex vent through the chimney from above (leave an extra 3' (914 mm) at the top).
3 Attach the flex vent to the manifold (seal with silicone and attach with screws).
4 Place the manifold in an upright position (so it rests on the manifold legs) and have a partner pull on
the excess flex vent. Temporarily attach the flex vent to the top of the chimney (leave extra slack).
5 Slide the insert into place, guiding the convection top over the insert until fully in place.
6 After removing any slack from the flex vent, attach the manifold to the appliance.
7 Remove any excess slack in the flex line then attach the vent termination.
4
4
3
2
1
5
7
6