beautypg.com

Ip module, Commlink 5 communications setting, 8 technical guide – Auto-Zone Control Systems IP Module Kit Installation Guide for the IP Module Kit Used with CommLink IV & 5 (Version 01N) User Manual

Page 8: Setting the commlink 5 setting communications, Mul t iple single loop

background image

IP MODULE

8

Technical Guide

CommLink 5 Communications Setting

Setting the CommLink 5

Setting

Communications

CommLink 5 Communications Setting

The Loop Switch Located On The Back Of The
CommLink 5 Housing Must Be Set Correctly For
Your Specific Application In Order For The
CommLink 5 To Function Properly.

The

Switch Setting Should Be Set To

“Multiple” In The Following Situation:

You Have A Single CommLink With
MiniLink(s) or MiniLink PD(s) Installed On
Your System.

The CommLink

5 Is Factory Set For Multiple Loop Applications.

Loop

The Loop Switch Setting Should Be Set To
“Single” In The Following Situation:

You Have A Single CommLink Without Any
MiniLinks Or MiniLink PDs Installed On Your
System.

MUL

T

IPLE

HIGH

SINGLE

LOW

BAUD

LOOP

R

(+)

24V

GND

SHLD

T(

-)

SERIAL #

MUL

T

IPLE

SINGLE

LOOP

Switch Set To Multiple
Loop Communications

MUL

T

IPLE

SINGLE

LOOP

Switch Set To Single
Loop Communications

Back of CommLink 5

Figure 4: Setting Loop Communications