beautypg.com

Ip module, Commlink 5 ip module installation, 6 technical guide – Auto-Zone Control Systems IP Module Kit Installation Guide for the IP Module Kit Used with CommLink IV & 5 (Version 01N) User Manual

Page 6: Ip module seated in socket

background image

IP MODULE

6

Technical Guide

CommLink 5 IP Module Installation

Installing the OE415-02 IP Module into the CommLink 5

CommLink 5 with OE415-02 IP Module Installed

LANTRONIX

WiPort NR

00-20-4A-89-6B-EE

WP5001000-01 Rev

.A1

1

Pat. 4972,470 06W21
Made in

Taiwan

IP Module Installation Instructions:
First Remove The Enclosure Screws That Hold
The Top And Bottom Of The CommLink
Enclosure Together. Remove The Top Half Of
The Enclosure To Access The Circuit Board And
IP Module Socket.

Insert The IP Module’s Guide Pins Into The
Round Pin Holes On The CommLink Circuit
Board As Shown. When The Pins Are Properly
Aligned, Press Down On The IP Module Firmly
To Seat It Into Its Socket.

After Making Sure The IP Module Is Firmly
Seated, Replace The CommLink Cover And
Secure The Enclosure Halves Back Together
With The Enclosure Screws That Were
Previously Removed.

Follow The Instructions In This Guide For
Installing The IP Module Software And
Configuring The IP Module For Your Control
System.

IP Module (Part Of OE415-02
IP Module Kit). Used When
TCP/IP LAN Or Internet
Communications With The
Control System Is Desired.

Location
Pin - Typ.

Round Pin Hole

IP Module
Socket

LANTRONIX WiPort NR

00-20-4A-89-6B-EE

WP5001000-01 Rev.A11
Pat. 4972,470 06W21
Made in Taiwan

IP Module
Seated In
Socket

PIC

32

24
VA
C

GND

T

SH

R

PIC

32

24
VA
C

GND

T

SH

R

PIC

32

24
VA
C

GND

T

SH

R

PIC

32

24
VA
C

GND

T

SH

R

Figure 2: Installing the IP Module into the CommLink 5