beautypg.com

Ip module, Commlink confi guration – Auto-Zone Control Systems IP Module Kit Installation Guide for the IP Module Kit Used with CommLink IV & 5 (Version 01N) User Manual

Page 14

background image

IP MODULE

14

Technical Guide

CommLink Confi guration

Changing the IP Address of the

CommLink

Follow the instructions below to set your IP Module’s IP address.

Be sure you have confi gured your PC’s IP address as described
on page 13.

1.) Run the Prism 2 program, open the Job Sites Window,
and type the default IP address 192.168.1.25 in the Node
IP Address
fi eld. See the Prism 2 Technical Guide if
needed for further instructions. To access the IP Module
web page, click on the

tab and then

click

(see below).

The IP Module web page should appear as shown in
Figure 14.

2.) Enter a password if required. By default, the
CommLink does not have a user name or password.

Figure 14: CommLink’s IP Module Home Page

Figure 15: CommLink’s IP Module Network
Confi guration Settings

4.) Under IP confi guration, select the radio button
in front of the option

confi guration>

and type in the IP address,

Subnet Mask, and Default Gateway as provided
by the jobsite IT staff.

NOTE:

Be sure all other settings are set to default as shown
in Figure 15.

5.) Click

at the bottom of the Network Settings

Screen once the changes have been made.

3.) Click

found in the menu

bar on the left side of the web page.