beautypg.com

Ip module, Commlink iv ip module installation, 5technical guide – Auto-Zone Control Systems IP Module Kit Installation Guide for the IP Module Kit Used with CommLink IV & 5 (Version 01N) User Manual

Page 5

background image

IP MODULE

5

Technical Guide

CommLink IV IP Module Installation

Figure 1: Installing the IP Module into the CommLink IV

Installing the OE415-02 IP Module into the CommLink IV

CommLink IV With OE415-02 IP Module Installed

LANTRONIX

WiPort NR

00-20-4A-89-6B-EE

WP5001000-01 Rev

.A1

1

Pat. 4972,470 06W21
Made in

Taiwan

IP Module Installation Instructions:
First Remove The Enclosure Screws That Hold
The Top And Bottom Of The CommLink
Enclosure Together. Remove The Top Half Of
The Enclosure To Access The Circuit Board And
IP Module Socket.

Insert The IP Module’s Guide Pins Into The
Round Pin Holes On The CommLink Circuit
Board As Shown. When The Pins Are Properly
Aligned, Press Down On The IP Module Firmly
To Seat It Into Its Socket.

While The Top Of The Enclosure Is Removed,
Make Sure That The SW1 DIP Switch Is Set
Correctly. See Figure 3.

After Making Sure The IP Module Is Firmly
Seated, Replace The CommLink Cover And
Secure The Enclosure Halves Back Together
With The Enclosure Screws That Were
Previously Removed.

Follow The Instructions In This Guide For
Installing The IP Module Software And
Configuring The IP Module For Your Control
System.

IP Module (Part Of OE415-02
IP Module Kit). Used When
TCP/IP LAN Or Internet
Communications With The
Control System Is Desired.

Location
Pin - Typ.

Round Pin Hole

IP Module
Socket

IP Module
Seated In
Socket

ALTERA

EPM3032

WattMaster Controls Inc.
COMMLINK IP
YS102074
REV6

MADE IN USA

LANTRONIX WiPort NR

00-20-4A-89-6B-EE

WP5001000-01 Rev.A11
Pat. 4972,470 06W21
Made in Taiwan

ALTERA

EPM3032

WattMaster Controls Inc.
COMMLINK IP
YS102074
REV6

MADE IN USA