Artesyn MVME721x RTM Installation and Use (April 2015) - Manual (Page 42)

Controls, LEDs, and Connectors
MVME721X RTM Installation and Use (6806800M42D) 42
3.3.1 Rear Panel Connectors
All connectors use standard pin assignments in compliance with the VMEbus specifications:
3.3.1.1 J1 (Serial) and J2 (Ethernet) Pinout Connectors
The pin assignments for the J1 and J2 connectors are as follows:
Table 3-3 Transition Module Connectors
Connector Function
J1A, J1B, J1C, J1D COM port connectors
J2A 10/100/1000Mb/s Ethernet connector
J2B 10/100/1000Mb/s Ethernet connector
J10 PIM power/ground
J14 PIM I/O
P2 VME backplane connector
Table 3-4 J1 and J2 Connector Pin Assignments
J1 J2
Pin Name Signal Description Pin Name Signal Description
A1 NC A1 E2_0P
A2 SP4_RTS A2 E2_0N
A3 GND A3 E2_1P
A4 SP4_TX A4 E2_1N
A5 SP4_RX A5 E2_2P
A6 GND A6 E2_2N
A7 SP4_CTS A7 E2_3P
A8 NC A8 E2_3N
B1 NC B1 E1_0P
B2 SP3_RTS B2 E1_0N
B3 GND B3 E1_1P