Artesyn MVME721x RTM Installation and Use (April 2015) - Manual (Page 37)

Hardware Preparation and Installation
MVME721X RTM Installation and Use (6806800M42D) 37
8. Carefully seat the RTM into the chassis by applying firm pressure to the RTM front panel,
near the Scanbe handles.
9. Verify that the RTM is properly seated and secure it to the chassis using the two screws
located adjacent to the Scanbe handles.
10. Connect the appropriate cables to the RTM.
2.3.3 Removing the RTM
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a
ground. The ESD strap must be secured to your wrist and the chassis to ground throughout
the procedure.
2. Turn off the power.
3. Disconnect the appropriate cables from the RTM.
4. Unfasten the screws located adjacent to the handles.
5. Fully open the upper and lower handles in outward direction.
6. Hold top and bottom edges of the RTM and exert minimal force when pulling RTM from
the chassis to prevent pin damage.
7. Slide the RTM from the rear guides of the chassis.
8. Carefully remove the RTM from the chassis and store in an anti-static envelope.
9. Install the filler panel into the appropriate slots at the rear of the chassis.
Scanbe handles cannot be used for card injection. Scanbe handles are for ejection purposes
only.
Make sure that the handles of both the RTM and the front blade are closed in order to power
up the blade and RTM payload.