Artesyn MVME721x RTM Installation and Use (April 2015) - Manual (Page 21)

Chapter 1
MVME721X RTM Installation and Use (6806800M42D) 21
Introduction
The MVME721X Rear Transition Module (RTM) of the blade (hereinafter referred as
MVME721X-RTM) must work with MVME721X blades.
The MVME721X RTM is for I/O routing through the rear of a compact VMEbus chassis. It
connects directly to the VME backplane in chassis with an 80 mm deep rear transition area. The
MVME721X RTM is designed for use with the MVME7100, MVME2500, iVME7210, and
MVME4100.
1.1 Features
The main features of the MVME721X RTM are as follows:
 One five-row P2 backplane connector for serial and Ethernet I/O passed from the SBC
 Four RJ-45 connectors for rear panel I/O: four asynchronous serial channels
 Two RJ-45 connectors with integrated LEDs for rear panel I/O: two 10/100/1000 Ethernet channels
 One PIM site with rear panel I/O
Figure 1-1 Block Diagram