beautypg.com

7 installing and removing the heat spreader/cooler – Artesyn COMX-P2020 Installation and Use (February 2015) User Manual

Page 39

background image

Hardware Preparation and Installation

COMX-P2020 Module Installation and Use (6806800K97E)

39

Installing the MicroSD Card

1. Insert the MicroSD card to the MicroSD socket.

2. Make sure that the metallic contact point of the MicroSD card and the MicroSD

socket are lined up correctly.

2.7

Installing and Removing the Heat

Spreader/Cooler

Installing the Heat Spreader/Cooler

1. Check the thermal interface material pads on the heat spreader/cooler. Make sure

the pads are aligned to their corresponding components on the COMX-P2020
module.

2. Align the standoffs of the heat spreader/cooler with the screw holes on the COMX-

P2020 Module.

3. Hold the heat spreader/cooler and COMX-P2020 Module.

4. From the backside of COMX-P2020 Module, use two screws to fasten the module

to the heat spreader/cooler through two internal mounting holes.

Removing the Heat Spreader/Cooler

1. Loosen and remove the two pieces of screws that attach the heat spreader/cooler

to the COMX-P2020 Module.

2. While holding the edges, pull the heat spreader/cooler from the COMX-P2020

Module.

2.8

Installing and Removing the Module on the

Carrier Board

The assembled COM Express module with the attached heat spreader/ cooler is attached to a
carrier board.