Artesyn COMX-P2020 Installation and Use (February 2015) - Manual (Page 35)

Hardware Preparation and Installation
COMX-P2020 Module Installation and Use (6806800K97E) 35
 Confirm the feasibility of the operation
There are available spare parts of the components to be installed or replaced in the
equipment warehouse. When the available spare parts are lacking, contact Artesyn
Embedded Technologies for help in time. For details on how to get help from EArtesyn,
visit http://www.artesyn.com/computing/.
Make sure that the new components are in good condition, without defects such as
oxidation, chemical corrosion, missing components, or transportation damage.
By reading this document, you are familiar with how to install and replace the component
and master the skills required by the operation.
 Check the environment
Make sure that the power supply, temperature, and humidity meet the operating
requirements for the board and its components. For details, refer to the respective system
documentation.
 Prepare the parts and the tools
Prepare the components to be installed or replaced.
When you hold or transport the components, use the special antistatic package. Prepare
the cross screwdriver, screws, plastic supports, cooling gel, and ESD-preventive wrist
strap.
 Confirm installation or changing position
Confirm the position where COMX-P2020 Module will be installed.
 If a serious problem occurs and cannot be solved when you install or replace the
component, contact Artesyn Embedded Technologies for technical support.
2.5 Installing and Removing the Memory Module
There is one 204-pin SOUDIMM slot on the COMX-P2020 Module.
Pin Damage
Forcing the module into the system may damage connector pins.
If the module hangs during insertion, pull it out and insert it again.