ART Pro Audio Quadra/Fx - Two Channel Effects Processor - Manual (Page 63)

- 60 -
MIDI PARAMETERS
The Quadra/FX has three types of programmable MIDI parameters: channel, MIDI map, and continuous controllers
(four per engine or engine group). Press the MIDI button and then turn the Encoder to access the MIDI parameters.
To edit the selected parameter’s value, press the Encoder and turn it. MIDI Controller Mappings have two associated
values and will require a second Encoder press to access the second value. Again, turn the Encoder to change
values. To repeat the MIDI parameter selection process, again press the Encoder and then turn it. You can exit MIDI
mode at any time by pressing any button other than Power, Store, or Bypass.
MIDI
Range: Smart Meter LEDs Flashing:
Channel Number ALL, 1–16 -24 (Channel)
MIDI Map OFF, 1–128 -18 (MIDI Map)
(Controller #1) Parameter Any Effect parameter, Smart Encoder, Bypass -12 (Controller)
Controller # 1–119, ON, OFF, At, Pb
(Controller #2) Parameter Any Effect parameter, Smart Encoder, Bypass -12 (Controller), -6
Controller # 1–119, ON, OFF, At, Pb
(Controller #3) Parameter Any Effect parameter, Smart Encoder, Bypass -12 (Controller), -6, 0dB
Controller # 1–119, ON, OFF, At, Pb
(Controller #4) Parameter Any Effect parameter, Smart Encoder, Bypass -12 (Controller), -6, 0dB, +6
Controller # 1–119, ON, OFF, At, Pb
CHANNEL NUMBER
The MIDI channel number is the channel that the Quadra/FX will receive and transmit all MIDI data on. When
editing this parameter, the Channel LED in the Smart Meter will flash. The Quadra/FX’s MIDI channel is
global to the whole unit, regardless of which preset, routing, engine, or effect it is set from, and it is
automatically saved whenever changed.
The range of this control is from 1 to 16, or , for Omni mode. If you select , the Quadra/FX will
receive data on all 16 MIDI channels, but only send out data on channel 1.
MIDI MAP
Each preset contains a single MIDI map value that determines which MIDI program change number will recall
the preset. When editing this parameter, the MIDI Map LED in the Smart Meter will flash. Each preset has just
one MIDI mapping, but it can be set and updated from within any engine.
The range of this control is from to $ , or . While editing this value, you can also conveniently set
the MIDI map by sending a MIDI program change message on the Quadra/FX’s MIDI channel. The
Quadra/FX will not internally change patches when this happens; it just sets the MIDI Map value to the patch
change number that it receives.