ART Pro Audio Quadra/Fx - Two Channel Effects Processor - Manual (Page 6)

- 3 -
board and not additionally at the Quadra/FX’s faders. One way to do this is to set EACH preset’s Mix
parameter to 100%. This would be a tedious process! Fortunately, there is a special Quadra/FX function
called Dry Kill that will conveniently turn off the dry signal path inside the unit. Each preset’s Mix value is still
retained, even though all dry sound is eliminated. To enable Dry Kill, press and hold the Bypass and
Parameter buttons, then release them both. Turn the Encoder until the Display reads: (the dry sound is
off). Now press any key to return to the presets. For more information on Dry Kill, see page 10.
STRAIGHT INTO AN AMP:
If you’re patching the Quadra/FX into an instrument amplifier or stereo monitor amplifier, use one cord
between the instrument and the Quadra/FX’s Input #1. Run a second cord from Output #1 to the amp’s input.
If the amp has stereo input capabilities, or if you’re using two amps, connect another cord between the
Quadra/FX’s Output #2 and the amplifier’s other input. You can also plug a second output from your
instrument (or the output from another instrument) into the Quadra/FX’s Input #2. Don’t forget that the
Quadra/FX can also be used as two separate, stereo processors, or even as four separate, mono processors.
Imagine the Power!
IN AN AMP’S EFFECTS LOOP:
If you’re patching the Quadra/FX into a guitar (or other instrument) amplifier’s mono effects loop, use one cord
between the amp’s effects send jack and the Quadra/FX’s Input #1. Run a second cord from Output #1 to the
amp’s Effects Return jack. (If the amp has stereo returns, use another cord to connect the Quadra/FX’s