beautypg.com

ART Pro Audio Quadra/Fx - Two Channel Effects Processor User Manual

Page 46

background image

- 43 -

Dynamic

A Dynamic Chorus can trigger the LFO through one cycle of its sweep when the input signal crosses above

the programmed Threshold level. When the input signal crosses back, the LFO is reset and will trigger again

the next time the input signal crosses over the Threshold level. Threshold is set with the Special parameter.

CHORUS

Delay
(Predelay
± 1 ms)

Size
(Predelay
± 50 ms)

Regen

Decay
(Fade
Time)

Shape
(LFO
Shape)

Pitch
(LFO
Offset)

Speed
(LFO
Rate)

Width
(LFO
Width)

Special

(*see
below)

Vocal

0–1000ms

0–1000ms

0–100

0–7

1–12

0–10.5Hz

0–100%

Threshold

Instrument

0–1000ms

0–1000ms

0–7

1–12

0–10.5Hz

0–100%

Concert

0–1000ms

0–1000ms

0–7

1–12

0–10.5Hz

0–100%

Gated

0–1000ms

0–1000ms

0–7

1–12

0–10.5Hz

0–100%

Threshold

Ambient

0–1000ms

0–1000ms

0–7

1–12

0–10.5Hz

0–100%

Diff. factor

Dynamic

0–1000ms

0–1000ms

0–7

1–12

0–10.5Hz

0–100%

Threshold

Delay:

Changes the predelay time in

±

1 millisecond steps. The total amount of predelay is 1 second (1000 ms.)

Size:

Changes the predelay time in

±

50 millisecond steps.

Regen

(Not used.)

Decay:

This parameter is used in Vocal class and sets the amount of time it takes the effect to fade in and out after

the Threshold level is crossed. A graph of this control’s action is on page 66.

Shape:

Selects the LFO shape. Use the LFO Shapes table to match the

parameter’s value with an LFO waveform. Also, see page 65 for graphs

of the various LFOs.

Pitch:

Controls the LFO phase difference (in 30° increments) between the two

outputs of an engine group (Outputs #1 and #2, or Outputs #3 and #4).

A setting of 0° creates a normal chorus where both channels’ LFOs

start at 0° (low). Any setting other than 0° will offset the second channel’s LFO by that

many degrees. (See the LFO Offset table.) Use this control to create uneven stereo

chorus effects.

Note: In Discrete 4 (mono) routing, this parameter is not available.

Speed:

Sets the speed of the LFO between 0 and 10.5 cycles per second (Hz.)

Width:

Sets the LFO modulation width, or amount, from 0% to 100%.

Special: In Vocal and Gated classes, Special sets the audio input level (Threshold) that

LFO Shapes

0

Exponential

1

Sine

2

Triangle

3

Rectified Sine

4

Inverted Rectified Sine

5

Square

6

Ramp

7

Inverted Ramp

LFO Offset

1

0

°

2

30

°

3

60

°

4

90

°

5

120

°

6

150

°

7

180°

8

210

°

9

240

°

10 270

°

11 300

°

12 330

°