Self-test diagnosis – Argox Ethernet printer User Manual
Page 47

Ethernet Printer Technical Manual November 10, 2010
47
12. SELF-TEST DIAGNOSIS
12.1 Perform Self-test Diagnosis
When the printer is first installed, a self test should be performed. To perform the self test, please
follow the below procedures:
Turn off the power.
Load the media (and ribbon, if using thermal transfer media instead of direct thermal
paper) properly.
Press and hold the
FEED
key, and then turn on the power.
Release the
FEED
key after the printer starts to print.
The configuration report should be printed as
Figure 12.1
.
To return the printer to its normal operation, please turn off the power and turn on the
power again or press the
CANCEL
key for one second. Otherwise, the printer will enter
dump mode, and all input data will not be interpreted.
.
Contents and Information of A-2240E “PPLZ Self Test Label” are as follows:
1. Printer Version Information
Displays the printer firmware version and date information.
2. Standard RAM Size
Displays the standard RAM size of the printer.
3. Available RAM Size
Displays the available memory that can be used to store the downloadable graphics, forms
and soft fonts.
4. Flash Type
Displays the flash type used in the printer.
5. Available Flash Size
Displays the available flash capacity that can be used to store the downloadable graphics,
forms and soft fonts.
6. Int. fonts
Displays the Asian font types downloaded to the printer.