Argox Ethernet printer - Manual (Page 17)

Ethernet Printer Technical Manual November 10, 2010
17
2. In the CONFIG ’s TCP/IP submenu, you can configure how the Ethernet card assigns the IP
address to the PC and other related settings.
3. In the
Maintenance submenu, you can update the firmware of the Ethernet card/printer.
The accumulative time will be reset if the printer shuts down. You can get this information from the
default webpage ( http://192.168.1.100/systeminfo/htm ) or other webpage.
When updating the firmware of the Ethernet card/printer, all status monitors including Bartender
status must be closed.
After updating the Ethernet module firmware or changing of the IP address is complete, restart
the printer and wait for about 1 minute; you will get the latest Ethernet module firmware version
or IP address by the printer self test pages.