Argox Ethernet printer User Manual

Page 31

Text mode
Original mode

Ethernet Printer Technical Manual November 10, 2010

9. Reboot Ethernet Card

When the Ethernet card is not functioning normally, we can restore its default settings by following
these steps:

1. Turn off the printer and remove all the printer covers.
2. Press and hold the

RESET

button, then turn on the printer. After 3 seconds, release the

RESET

button. At this time, the Ethernet card enters the

boot loader

mode and only the Green LED lights

on.

3. You can check whether the Ethernet card enter the boot loader or not by sending the DOS

command –

ping 192.168.1.100

4. Download the Ethernet card firmware by entering

tftp –i 192.168.1.100 put ARGOX_v0.71

. Wait

for 40 seconds to let the Ethernet card automatically restart or until the Amber LED blinks and the
Green LED lights on. (

ARGOX_v0.71

is the Ethernet card firmware and it should be placed at the

corresponding working directory).