AGI Security SYS-HC0451S2 - Manual (Page 96)

86
3 Installation and Connections
Note: All the installation and operations here should conform to your local electric
safety rules.
3.1 Check Unpacked DVR
When you receive the DVR from the forwarding agent, please check whether there is any visible
damage. The protective materials used for the package of the DVR can protect most accidental clashes
during transportation. Then you can open the box to check the accessories.
Please check the items in accordance with the list. Finally you can remove the protective film of the DVR.
3.2 About Front Panel and Rear Panel
The model label in the front panel is very important; please check according to your purchase order.
The label in the rear panel is very important too. Usually we need you to represent the serial number
when we provide the service after sales.
3.3 HDD Installation
Important
Shut down the device and then unplug the power cable before you open the case to
replace the HDD!
All figures listed below for reference only!
You can refer to the Appendix for recommended HDD brand. Please use HDD of 7200rpm or higher.
Please follow the instructions below to install hard disk.
3.3.1 Econimic 720P /Econimic 720P(V2) /1080P(V2)/ Econimic 720P （S2） Smart
1U/ General 720P (S2) Smart 1U/1080P (S2) Smart 1U Series
The series DVR has one SATA HDD.
○ 1 . Loosen the screws of the upper
cover and side panel.
○ 2 Fix four screws in the HDD
(Turn just three rounds).
○ 3 Place the HDD in
accordance with the four holes
in the bottom.