AGI Security SYS-HC0451S2 - Manual (Page 113)

103
Figure 4-20
4.4.2.2 Call PTZ Function
Call Preset
In F igure 4-15, input preset value and then click to call a preset. Click again to stop call.
Call Pattern
In F igure 4-15, input pattern value and then click to call a pattern. Click again to stop
call.
Call Tour
In F igure 4-15, input tour value and then click to call a tour. Click again to stop call.
Call Scan
In F igure 4-15, input Scan value and then click to call a tour. Click again to stop call.
Rotate
In F igure 4-15, click to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
 Preset, tour and pattern all need the value to be the control parameters. You can define it as you
require.
 You need to refer to your camera user’s manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The
aux number is corresponding to the aux on-off button of the decoder. See Figure 4-21.