Adept Smart Vision MX - Manual (Page 19)

Chapter 2: Installation
If your system has sDIO or sMI6, these need to be placed between the Adept SmartController
and the Adept SmartVision MX industrial PC, so the power can be daisy-chained. The Adept
SmartVision MX industrial PC has only one 24 VDC plug. The other units have two.
If you are connecting peripherals to the Adept SmartVision MX industrial PC, you may need
to run a dedicated 24 VDC cable to the Adept SmartVision MX industrial PC, rather than tap-
ping power from the controller or your power supply. Make sure you are not exceeding the cur-
rent capacity of the controller 24 VDC plug.
2.5 Connecting Display, Keyboard, and Mouse
To connect a display to the SmartVision MX industrial PC, use either of the DVI- ports. If you
have a VGA display, you will need to use the DVI-I port with a VGA adapter.
Connect your keyboard and mouse to USB ports.
Adept SmartVision MX User’s Guide, Rev. A
Page 19 of 34