Adept Smart Vision MX - Manual (Page 16)

Chapter 2: Installation
NOTE: Connectors on the Adept SmartVision MX industrial PC are not shown in
this graphic.
NOTE: The same mounting brackets will work for either a SmartController EX or
CX motion controller.
2.4 Connecting Power
Connect 24 VDC power to the input of the SmartVision MX.
External Power Supply
The SmartVision MX takes 4.2 A at 24 VDC. It requires filtered 24 VDC power.
NOTE: You must provide your own power supply. Make sure the power cables
and power supply conform to the specifications in the following table.
Customer-Supplied
Power Supply 24 VDC (-10%, +5%), 150 W (6 A)
Circuit Protection Not more than 8 A (below the amper-
age rating of the cable used)
Power Cabling 1.5 - 1.85 mm 2 (16-14 AWG), full-
cover, braided shield cable, maximum
length 10 meters
Shield Termination Braided shield connected to the left
wire slot of the VDC connector on the
power side of the Adept SmartVision
MX. On the other end of the cable, the
shield should be connected to the
power supply chassis.
CAUTION: Make sure you select a 24 VDC power supply that meets
the specifications in the preceding table. Using an underrated supply
can cause system problems and prevent your equipment from oper-
ating correctly. See the following table for recommended power sup-
plies.
Table 2-1. Recommended 24 VDC Power Supplies
Vendor Name Model Ratings
XP Power JPM160PS24 24 VDC, 6.7 A, 160 W
Mean Well SP-150-24 24 VDC, 6.3 A, 150 W
Adept SmartVision MX User’s Guide, Rev. A
Page 16 of 34