Adept Smart Vision MX - Manual (Page 13)

Adept SmartVision MX User’s Guide, Rev. A
Page 13 of 34
Chapter 2: Installation
The Adept SmartVision MX should be shipped and stored in the Adept-supplied packaging,
which is designed to prevent damage from normal shock and vibration. You should protect
the package from excessive shock and vibration. For environmental specifications, refer to
Environmental Specifications on page 27.
2.1 Inspecting
Carefully inspect all packaging for evidence of damage during transit. If any damage is indic-
ated, request that the carrier’s agent be present at the time the package is opened.
Compare the actual items received (not just the packing slip) with your equipment purchase
order, and verify that all items are present and that the shipment is correct. Inspect each item
for external damage as it is unpacked. Contact Adept immediately if any damage is evident.
See “How Can I Get Help?” section on page 15.
Retain all containers and packaging materials. These items may be needed in the future to
settle a damage claim.
Remove the Adept SmartVision MX. Mount it near the robot.
2.2 Transport and Storage
The Adept SmartVision MX must be shipped and stored in a temperature-controlled envir-
onment, within the range -40° to +85° C (-40° to 185° F). The recommended humidity range is 5
to 90%, non-condensing.
It must always be stored and shipped in a clean, dry area that is free from condensation.
2.3 Mounting the SmartVision MX
NOTE: The SmartVision MX is not intended for use in hazardous environments
(explosive gas, water, dust, oil mist).
Space Around the Chassis
When the SmartVision MX is installed, allow adequate space around the unit for air cir-
culation.
Desk-top Mounting
The base of the industrial PC has tabs with holes for screwing it to the top of a flat surface.