Zilog ZUSBOPTS User Manual
Page 39
UM025603-0814
Establish A Wireless Connection
Zilog Educational Shields
User Manual
32
11. Observe the Console 1 prompt change to
, as shown in Figure 30.
12. The wireless link is now established, and the commands issued on Console 1 at the
prompt will remotely control Console 2. To verify that this link is operat-
ing correctly, the output status LED on the Z-PAN Shield will now be illuminated in a
solid green color, and should not be blinking.
13. Demonstrate the control of Console 2 by entering the following command on Console
1:
Setpins pa 07 on
The PA0, PA1 and PA2 LEDs on the Test Shield connected to Console 2 should now
be illuminated.
14. To turn off Port A bits 0, 1, and 2, enter the following command:
Setpins pa 07 off
15. To close the communication link, enter the
Ctrl-D
command on both consoles, or
press the reset button on the Platform. To gain remote control of the opposite shield,
simple reverse this procedure.
Figure 30. Module 1 Prompt After wremotehost Command