Zilog ZUSBOPTS - Manual (Page 10)

UM025603-0814 Educational Platform Setup
Zilog Educational Shields
User Manual
3
2. Connect the 9 V wall power adapter or the 9 V battery to the Platform, but do not turn
the power on to the Platform.
3. Connect the Mini-B connector end of the A to Mini-B USB cable to the J5 connector,
and connect the other end of this cable to the target PC. Ensure that Power Select
Switch SW2 is in the correct position for the type of power being applied. For exam-
ple, if you are using the 9 V battery, move the switch to BATT; if using power sourced
from the wall outlet, move the switch to VMAIN.
If the Windows OS displays a Driver Not Found message, you must install a USB
driver. A standard USB driver ships with the USB Flash drive you received with your Kit;
however, the same driver can be downloaded for free from the FTDI website at
http://
www.ftdichip.com/Drivers/VCP.htm .
Figure 1. Key Alignment Between the Educational Platform and the Test Shield
Note: