Zilog ZUSBOPTS - Manual (Page 37)

UM025603-0814 Establish A Wireless Connection
Zilog Educational Shields
User Manual
30
4. At the blinking square prompt in each console screen, and with Figures 26 and 27 as
your guide, enter the BTA number generated in your shield’s remote address settings.
In the remaining steps for this procedure, this BTA number will be referred to as BTAnum .
5. On one console, enter the sr,BTAnum command, then press the Enter key twice.
6. Enter the d command, and verify that the value of Rem has now changed to the other
shield’s address, as shown in Figures 26 and 27.
7. Enter the c command on the same console to establish a wireless connection.
8. Enter the Ctrl-D command on both terminals to return to the ZEdulab> prompt in
the root shell.
9. Enter the wreset command to reset the shields on both consoles.
The wreset command must be executed for the changes to the remote address to take
effect. As an alternative to the wreset command, a power on/off reset can also be exe-
cuted.
Figure 27. Module 2 Remote Address Settings
Note:
Note: