WaveWare Adaptive Remote - Manual (Page 18)

BetaBrite Programming Manual (pn 9703-6020) November 4, 2003
18 Basic sign operation
Setting a sign’s password
You can set a personal password to protect your messages and
graphics from tampering by others.
If you forget the password, see “What to do when you forget a sign’s
password” on page 19.
Step When you do this . . . You see this . . .
1 Press PROGRAM.
2 Press BACK until SET PASSWORD appears.
3 Press ADV.
4 Press Y to set a password.
5
Type a 6-character password. (Only asterisks
will appear on the sign as you type.)
Re-type the password when prompted.
CORRECT will appear if you entered the same
password.
If you failed to type the same password,
ERROR will appear, and you’ll have to start
over from Step 1.
6 Press RUN twice.
7
Press Y to password protect the sign
NOTE: If you select N, then a password will
not be needed when you press
PROGRAM.
PROG TEXT A
SET PASSWORD
SET PASSWORD? Y/N
ENTER 6 CHAR’S
******
THEN
RE-ENTER THE 6
THEN
******
THEN
CORRECT
PROG TEXT A
PASSWORD RUN? Y/N
SECURE
The sign will return to normal operation.
Now, whenever you press PROGRAM, you’ll
have to type the password you just entered.