Vectronics VEC-8218K - Manual (Page 6)

VEC-8218K Owner’s Manual Counter-Surveillance Monitor Kit
6
! 6 .01 uF multilayer capacitor (103) C2,C3,C4,C5
C6,C7 220-2100
! 2 10 uF electrolytic capacitor C9,C10 270-5100-1
! 1 LM324 quad op-amp IC (14 pins) U1 324-0324
! 1 MRF901 transistor (4 leads) Q1 306-5901
! 2 PN2222 transistor Q2,Q3 305-2222-1
! 1 1N270 detector diode D1 300-0034
! 1 Sub-miniature speaker SPK1 410-0011
! 1 9V battery snap BAT1 730-3005
! 6 3” length of insulated wire 871-2444-0300
! 1 Telescoping antenna ANT 758-1120
! 1 Solder lug 720-1213
! 1 3.5 x .6 - 6mm screw 675-0006B
! 1 Printed circuit board 861-VEC8218
! 1 Owner’s Manual 925-VEC8218K
PARTS PLACEMENT
STEP-BY-STEP ASSEMBLY INSTRUCTIONS
In these instructions, when you see the term install, this means to locate, identify,
and insert the part into its mounting holes on the PC board. This includes pre-
bending or straightening leads as needed so force is not required to seat the part.
Once a component is mounted, bend each lead over to hold it in place. Use
sharp side-cutters to clip off excess lead length before soldering. Make sure
trimmed leads don't touch other pads and tracks, or a short circuit may result:
Good Not Good