Vectronics VEC-1500K - Manual (Page 54)

49
VECTRONICS SOLDER COURSE LAB
Parts List
Your kit should contain all of the parts listed below. Please go through the parts
bag to identify and inventory each item on the checklist before you start
building. If any parts are missing or damaged, refer to the warranty section of
this manual for replacement instructions. If you can't positively identify an
unfamiliar item in the bag on the basis of the information given, set it aside until
all other items are checked off. You may then be able to identify it by process of
elimination. Finally, your kit will go together more smoothly if parts are
organized by type and arranged by value ahead of time. Use this inventory as an
opportunity to sort and arrange parts so you can identify and find them quickly.
Qty Part Description Designation
1 75K-ohm ¼-watt resistor
(violet-green-orange) R2
11 10K-ohm ¼-watt resistor
(brown-black-orange-gold) R4,R5,R6,R7,R8,R9,R10,R11,R12,R13
10 1K-ohm ¼-watt resistor
(brown-black-red-gold) R1,R14,R15,R16,R17,R18,R19,R20,
R21,R22,R23
1 1-uF electrolytic capacitor C1
3 .1-uF monolithic capacitor C2,C3,C4
10 2N3904 NPN transistor Q1,Q2,Q3,Q4,Q5,Q6,Q7,Q8,Q9,Q10
1 555 8-pin IC U1
1 4017 16-pin IC U2
10 Red LEDs CR0,CR1,CR2,CR3,CR4,CR5,CR6,
CR7,CR8,CR9
1 1N4148 Silicon diode D1
1 9-volt battery clip
1 8-pin IC socket for U1
1 16-pin IC socket for U2
1 DPDT push-action switch SW1
5 4” nylon wire tie
1 30” length of insulated wire
1 VEC-1500K PC board