Vectronics VEC-102K - Manual (Page 16)

16
2 - PC-mount 1/8" stereo phone jack [J2,J3]
1 - Insulated binding post (antenna) [J1]
1 - PC-mount push-button switch (DC on/off) [SW2]
1 - 5-position rotary switch (bandswitch) [SW1]
HARDWARE & MISCELLANEOUS
1 - Pre-drilled printed circuit board
1 - 9-volt battery snap connector
1 - 9-volt battery bracket with foam adhesive strip
1 - Aluminum chassis (bottom section)
1 - Aluminum cover
2 - 4-40 machine screws
2 - 4-40 standoff spacers
2 - 4-40 self-locking machine nuts
1 - 10-32 machine screw (for ground connector)
2 - 10-32 self-locking machine nuts
2 - 10-32 steel washers
1 - 10-32 wing nut
3 - 3/8" hex panel nuts (to mount controls and SW1)
3 - 3/8" steel washers (for controls and SW1)
2 - Instrument knobs for controls
1 - Pointer knob for band switch
1 - Larger (1.25") knob for tuning
1 - Pointer assembly for tuning capacitor
8 - Pan-head phillips screws for cabinet assembly
4 - Rubber bumper feet (self-adhesive)
1 - Set of hookup wires for jumper, winding L5
1 - Wire-tie to secure battery snap wires
1 - Instruction/Assembly manual
REQUIRED, NOT SUPPLIED
9-volt alkaline or heavy-duty battery
Low impedance stereo headphones ("Walkman" type)
Antenna wire
MINIMUM TOOLS REQUIRED
Soldering iron (20 to 30 watts)
Rosin-core solder intended for electronics work
Diagonal cutters or wires nippers
Small or medium phillips screw driver
Pliers or set of nutdrivers
Miniature jeweler-type flat blade screwdriver to adjust C5
Set of Allen hex wrenches (1/16" & 5/64)