TabletKiosk eo a7330 Ultra-Mobile - Manual (Page 60)

Chapter 04: Using Your eo a7330 with Windows 45
6. If DHCP is used on your
network, tap “Obtain an IP
address automatically” and
“Obtain DNS server address
automatically”. Otherwise,
enter the correct IP and DNS
server addresses by selecting
the two options that begin
with “Use the following…” If
you are unsure of which
option to use, contact your
network administrator or
your ISP’s Tech Support.
7. After entering the correct the information in the “Internet
Protocol (TCP/IP) Properties” window, tap “OK” to accept
your changes and close the window. Tap “OK” in the “Local
Area Connection Properties” window to finish.
Using Both DHCP and a Static IP Address
If you are using alternating networks with either DHCP or static
IP addressing, you can use alternative settings that will enable
simultaneous configurations of both DHCP and a static IP. This
will allow you to connect to both of the networks without having
to reconfigure each time you want to switch.
1. Follow steps 1 through 7
above when using a wired
LAN connection.
2. Tap on the “Alternate
Configuration” tab
and select the “User
configured” option. Enter
the correct values in
the appropriate fields. If
you are unsure of which
values or options to use,