Proceed PAV User Manual

Page 64

programming

memory buttons

To program the Memory Buttons, follow these steps:

Select the section that you wish to program the Memory Button
in by pressing the corresponding Device button (

audio

sat

)

and mute button, simultaneously.

SET

will appear in the LCD.

Press one of the Memory Buttons (

power/

standby

) into which you wish to store the functions.

M(1-5)_##

will appear in the LCD.

NOTE:

The

mute

button is used to designate POWER/STANDBY commands

during Memory button programming.

Press in up to fifteen commands that you want stored in that
Memory button. Each successive button selection will appear
as

M(1-5)_(01-15)

in the LCD.

You can select functions from another mode by first pressing
the corresponding Device button and then the buttons where
those functions are located in that mode. The pressing of a
Device button also counts as one command.

NOTE:

Each insertion of a Device Button adds a 1/2-second delay to the

command sequence.

Press the

channel +

button to store your selections.

SAVE

will

flash three times in the LCD to confirm the programming.

IMPORTANT NOTE:

If you attempt to store more than 15 commands, the entire

sequence of macros entered will clear and you will need to start over.

NOTE:

It can take up to 15 seconds to send out 15 commands from a memory

button.

Please continue to point the remote control at the device(s) until all the

commands on the Memory Button have been sent out. This will ensure that all
the commands are received by the device(s).

Example:

To program your TV, Cable Box and the PAV to turn on when the

power

button is pressed, first press-and-hold the sat and mute buttons until

SET

appears in the LCD. Next, press the

mute

button to enter the Power commands

for the PAV. Press

to select the TV mode, and then press the

mute

button

again, to select TV Power. Finally, press

cbl

followed by the

mute

button to

select Cable power. Press the

channel +

button to enter the commands.

After following these steps, each time you press the power/standby button,
after either the sat, tv, vcr or cbl Device control selector has been pressed, the
remote will send the “Power On/Off” command.