Proceed PAV User Manual

Page 55

• Increase or decrease the head-to-head distance between the

two remote controls, within a 1 to 5 inch range.

• Increase or decrease the time you press-and-hold the button on

the original remote control in step 5, for 1 to 2 seconds.

• Avoid fluorescent lights or strong sunlight during the set-up.

These lighting conditions can cause interference with the
learning process.

• Verify that the original remote control contains fresh batteries.

Some remote controls operate at non-standard IR, UHF or ultrasonic frequencies,
and are unable to be learned. If you continue to experience difficulty during
set-up, please contact authorized dealer for assistance.

learning new functions

on device buttons

The eight Device buttons at the top of the remote control can also learn new
functions. These buttons can only be set up in the Audio mode. If a new func-
tion is learned on a Device button, the new function will override any existing
preprogrammed information on the Device button.

Place the PAV remote and the original remote control to be
learned from, on a flat surface. Line up the remote controls
head-to-head, about two to three inches apart.

Press-and-hold both the

audio

and

play

buttons simultaneously,

for about three seconds, until the LCD on the PAV remote shows

LEARN

. The PAV remote is now in the learning mode.

NOTE:

Each of the following steps must be completed within 20 seconds. If the

remote does not receive any commands within the allotted time, it will return
to its normal operating mode.

Press-and-release one of the eight Device buttons on the PAV
remote. The LCD will show

READY

Press-and-hold the button on the original remote control you
wish to teach into the PAV remote, for about three seconds.
The LCD on the PAV remote will show

– – – –

indicating that it

is receiving the information from the original remote control.

Release the button on the original remote control. The LCD on
the PAV remote will show

RETRY

Press-and-hold the same button on the original remote again,
for about three seconds. The LCD on the PAV remote will flash

GOOD

, the

Device Mode

and then return to

LEARN

, verifying

that the new function has been learned.

Repeat Steps 3 through 6 for any other buttons you wish to learn new
functions.

Once you have completed the learning for all the desired
Device buttons, store the learned functions by pressing the

audio

and

play

buttons simultaneously, once again. The LCD

in the PAV remote will show

SAVED

and then return to the

AUDIO

mode. The remote has now returned to the original

operating mode.