Proceed PAV - Manual (Page 54)

54
learning new functions on the
main keypad
1 Select the mode in which you wish to learn the new function
by pressing the corresponding Device button.
2 Place the PAV/PDSD remote and the original remote control to
be learned from, on a flat surface. Line up the remote controls
head-to-head, about two to three inches apart.
audio pav
cd
dvd
aux cbl
vcr
tv
sat standby mute
power
input prev
record
adjust
channel
next
volume volume play
rev
fwd
pause
stop
2" to 3"
audio
pav
cd dvd aux
cbl vcr tv sat
standby
mute
power
input
prev
record adjust channel
next
volume
volume
play rev fwd
pause stop
Device Buttons
Play Button
3 Press and hold both the Device button selected in Step 1
and the
play button for about three seconds, until the LCD on
the PAV remote shows LEARN . the PAV remote is now in the
learning mode.
NOTE: Each of the following steps must be completed within 20 seconds. If
the remote does not receive any new commands within the allotted time, it
will return to its normal operating mode.
4 Press and release a button on the PAV remote you have
selected to learn the new function. The LCD will show
READY .
5 Press and hold the button on the original remote control for
about 3 seconds from which you are learning the new function.
The LCD on the PAV remote will show – – – – indicating that it is
receiving the information from the original remote control.
6 Release the button on the original remote control. The LCD on
the PAV remote will show
RETRY .
7 Press and hold the same button on the original remote once
again, for about three seconds. The LCD on the PAV remote
will flash
GOOD , the Device Mode and then return to LEARN ,
verifying that the new function has been learned.
Repeat Steps 4 through 7 for any other buttons you wish to learn new
functions.
8 Once you have completed the learning for all the desired but-
tons in a Device mode, store the learned functions by pressing
the device and play buttons simultaneously, once again. The
LCD in the PAV remote will show
SAVED and then return to
the Device Mode . The remote has now returned to the original
operating mode.
Once you have stored the learned functions, test the buttons that have been
taught. If any of the buttons do not operate as they should, please repeat from
Step 1 for those buttons.
NOTE: If the LCD shows FAIL at any time during the learning process, the PAV
remote was unable to learn the new functions. Please repeat from Step 4. If
the remote continues to show
FAIL during the learning process, please try the
following suggestions: