One Systems PT-10 User Manual
Page 18
One Systems, Inc. 6204 Gardendale Dr., Nashville, TN 37215
18
FIGURE 11a
Figure 12 shows a One Systems 103IM mounted to a PT10. There are 4 M5 stainless
steel bolts that are supplied with the PT-10 for mounting to either the 103IM or the
106IM. Once the PT-10 is mounted to the specific loudspeaker enclosure the two
stainless steel bolts on the center piece of the PT-10 may be loosened to allow the
bracket to be rotated in both the “pan” and “tilt” axis. Once proper loudspeaker aiming is
achieved both of these bolts must be securely fastened to insure the assembly will not
move.
NOTE: It is strongly recommended that a “temporary” thread locker be used to secure
the two M6 bolts that set both the pan and the tilt angles of the PT-10.
NOTE: It is necessary to fit an additional/secondary safety assembly
between the loudspeaker enclosure and the mounting surface. This safety
assembly is not supplied by One Systems. The safety assembly must
conform to local and national codes!
Figure 12