One Systems PT-10 User Manual
Page 13
One Systems, Inc. 6204 Gardendale Dr., Nashville, TN 37215
13
quick links with the turnbuckle is based on the tilt angle of the enclosure. The turnbuckle
should always be used.
DO NOT SUBSTITUTE ANY PART OF THIS LINK ASSEMBLY!
The Link should be tightened by rotating the turnbuckle until there is
tension on the Link assembly. Do not over tighten. The purpose of the Link
is to provide support for the main Pole Mount System tilting bracket at the
bottom of the assembly.
The back plate sections of the PT-76a and PT-38a have eyebolts attached to them.
There are 3 eyebolts on the back plate section of the PT-76a and 2 eyebolts on the
back plate section of the PT-38a. Figure 7 illustrates which eyebolt should be used for
each down tilt angle.
PT-76a PT-38a
Figure 7
Make sure to use the appropriate combination of Link parts to insure proper connection
between the PT bracket assembly and the specific One Systems enclosure. The
required combination of Link parts is determined by the down tilt angle of the enclosure.
The assembly may be configured with any combination of turnbuckle, chain link
sections and quick link in order to achieve the proper tension on the system, but the
turnbuckle must always be used. Figures 8a, 8b, and 8c show a 108IM and PT-38a at