NEXCOM VTC 6200 - Manual (Page 65)

Copyright © 2011 NEXCOM International Co., Ltd. All rights reserved 52 VTC 6200 / VTC 6200-NI / VTC 6200-NI-DK User Manual
Chapter 3: System Setup
Installing the SODIMM
1. Insert the module into the socket at an approximately 30 degrees
angle. Apply firm even pressure to each end of the module until it slips
into the socket. The gold-plated connector on the edge of the module
will almost completely disappear inside the socket.
SODIMM
socket
SODIMM
2. Push the module down until the clips on both sides of the socket lock
into position. You will hear a distinctive “click”, indicating the module
is correctly locked into position.
Clip Clip