NEXCOM VTC 6200 - Manual (Page 19)

Copyright © 2011 NEXCOM International Co., Ltd. All rights reserved 6 VTC 6200 / VTC 6200-NI / VTC 6200-NI-DK User Manual
Chapter 1: Product Introduction
Startup and Shutdown Mode (Refer to SW2 setting)
The start up and shut down setting modes are as follows.
1. Mode A (default setting). When the input power voltage is 12V, use
SW2 to select this voltage. Use the BIOS to select the start up and shut
down voltages.
2. Mode B. When the input power voltage is 24V, use SW2 to select this
voltage. Use the BIOS to select the start up and shut down voltages.
3. Mode C. When the input power voltage is 48V, use SW2 to select this
voltage. Use the BIOS to select the start up and shut down voltages.
Vehicle PC Mode
Mode A (default setting). When the ignition is from “low” to “high”, VTC
6200 / VTC 6200-NI / VTC 6200-NI-DK will turn on automatically. When
the ignition is “high”, press the power button to turn off VTC 6200 / VTC
6200-NI / VTC 6200-NI-DK.
When the ignition is from “high” to “low”, VTC 6200 / VTC 6200-NI /
VTC 6200-NI-DK will turn off automatically.
Getting to Know VTC 6200 / VTC6200-NI
VTC6200-NI-DK
Front Panel
WiFi/Bluetooth module
antenna mounting holes GPRS/UMTS/HSDPA module
antenna mounting holes
Power button
LEDs
USB
Reset button
SIM card socket
Line-out
Mic-in