Sdio configuration, Usb configuration – NEXCOM NISE 90 User Manual
Page 52
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
38
NISE 90 User Manual
Chapter 4: BIOS Setup
Sdio Configuration
This section is used to configure the SDIO access mode.
Advanced
Version 2.10.1208. Copyright (C) 2010 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Auto Option: Access SD device in
DMA mode if controller support
it, otherwise in PIO mode. DAM
Option: Access SD device in DMA
mode. PIO Option: Access SD
device in PIO.
Sdio Configuration
SDIO Access Mode
[Auto]
SDIO Access Mode
DMA
Auto
PIO
Sdio Configuration
Auto Option
Access SD device in DMA mode if controller support it,
otherwise in PIO mode.
DAM Option
Access SD device in DMA mode.
PIO Option
Access SD device in PIO mode.
▲
▲
Advanced
Version 2.10.1208. Copyright (C) 2010 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enables Legacy USB support.
AUTO option disables legacy
support if no USB devices are
connected. DISABLE option will
keep USB devices available
only for EFI applications.
USB Configuration
USB Devices:
1 Keyboard
Legacy USB Support
EHCI Hand-off
Device Reset timeout
[Enabled]
[Enabled]
[20 sec]
USB Configuration
This section is used to configure the USB.
Legacy USB Support
Enable Enables Legacy USB.
Auto
Disables support for Legacy when no USB devices are connected.
Disable Keeps USB devices available only for EFI applications.
EHCI Hand-off
This is a workaround for OSes that does not support EHCI hand-off. The
EHCI ownership change should be claimed by the EHCI driver.
Device Reset Timeout
USB mass storage device start unit command timeout.