Set password, Save & exit setup – NEXCOM NISE 2000 User Manual

Page 76

NISE 2000, NISE 2010, NISE 2020 User Manual

Chapter 4: BIOS Setup

Set Password

The User Password utility sets the password. The main board is shipped
with the password disabled. If you want to change the password, you
must first enter the current password, then at the prompt enter your new
password. The password is case sensitive. You can use up to eight alpha-
numeric characters. Press after entering the password. At the next
prompt, confirm the new password by retyping it and pressing
again.
To disable the password function, highlight “Set Password” then press
, instead of typing in a new password. A message appears con-
firming that the password has been disabled. If you have set supervisor
and user Password, only the supervisor password allows you to enter the
BIOS setup program.

Save & Exit Setup

Selecting this option and pressing will save the new setting infor-
mation in the CMOS memory and continue with the bootup process.

Note: If you forgot your password, the only way to solve this problem is
to discharge the CMOS memory by turning power off and placing a shunt
(jumper cap) on the RTC Clear jumper to short pin 2 and pin 3 for five
seconds, then putting the shunt back to pin 1 and pin 2.

This manual is related to the following products:

NISE 2010 NISE 2020