NEXCOM NISE 2000 User Manual

Page 72

NISE 2000, NISE 2010, NISE 2020 User Manual

Chapter 4: BIOS Setup

Soft-Off by PWR-BTTN

This field allows you to select the method of powering off your system.

Delay 4 Sec.
Regardless of whether the Power Management function is enabled or
disabled, if the power button is pushed and released in less than 4 sec,
the system enters the Suspend mode. The purpose of this function is
to prevent the system from powering off in case you accidentally “hit”
or pushed the power button. Push and release again in less than 4
sec to restore. Pushing the power button for more than 4 seconds will
power off the system.

Instant-Off
Pressing and then releasing the power button at once will immediately
power off your system.

PWRON After PWR-Fail

Off
When power returns after an AC power failure, the system’s power is
off. You must press the Power button to power-on the system.

On
When power returns after an AC power failure, the system will auto-
matically power-on.

Former-Sts
When power returns after an AC power failure, the system will return
to the state where you left off before power failure occurs. If the
system’s power is off when AC power failure occurs, it will remain off
when power returns. If the system’s power is on when AC power fail-
ure occurs, the system will power-on when power returns.

Wake-Up by PCI Card

Enabled
This field should be set to Enabled only if your PCI card such as LAN
card or modem card uses the PCI PME (Power Management Event)
signal to remotely wake up the system. Access to the LAN card or PCI
card will cause the system to wake up. Refer to the card’s documenta-
tion for more information.

Disabled
The system will not wake up despite access to the PCI card.

Power On By Ring

Set this field to Enabled to use the modem ring-on function. This will al-
low your system to power-on to respond to calls coming from an external
modem.

Wake Up On LAN

Set this field to Enabled to wake up the system via the onboard LAN or via
a LAN card that supports the remote wake up function.

USB KB Wake-Up From S3

This field, when enabled, allows you to use a USB keyboard to wake up a
system that is in the S3 (STR - Suspend To RAM) state. This can be config-
ured only if the “ACPI Suspend Type” field is set to “S3(STR)”.

This manual is related to the following products:

NISE 2010 NISE 2020