Junger Audio d06 - Digital Audio Leveler - Manual (Page 44)

5. OPERATION
operation manuad d06, chapter 5 - Operation - page 2 of 8
The picture below shows an example main display after power on:
OP ……..… IIIII PEAK
-18.0 … IIIIII ……. -9.0
The top display shows the current limiter gain reduction
[0dB at right hand], while the bottom display shows momentary gain
change introduced by the leveler process [0dB at center].
There are two reference levels :
OP
= Operating Level (target level of the leveler process)
PEAK = Peak Level (Threshold of the brick wall limiter)
These are top level settings. They can be adjusted without calling the
menu :
Simply press the respective up and down arrow buttons to
change values. The range of the settings are :
OP
= -40 … 0dBFS in steps of 1dBFS
PEAK = -20 … 0dBFS in steps of 0,1dBFS
Î If you press the arrow button for more than 2,5 sec. the values will
change automatically
Î Push the OK button to display the actual input level in
numeric values
Press
PRESET CONFIG PARAMETER PRESET
Press to open one of the selected menus.
PRESET
Press to enter the PRESET menu :
LOAD
PRESET 1: PR 1
5.2.1
Setting the
reference levels
5.2.2
Menu selection
5.2.3
Preset menu