Junger Audio d06 - Digital Audio Leveler - Manual (Page 16)

3. INSTALLATION
operation manual d06, chapter 3 - Installation - page 2 of 10
The digital audio level processor d06 has a digital signal output. For the
problem-free combination of following digital devices, the digital signal
processing can be locked to an external clock reference. The selection of the
corresponding sync source is made in the SYNC MODE menu during setup. If
the chosen sync input is connected with the sync signal, this signal is used for
synchronization automatically. All sync sources can be used for locking A/D-
converters at the analogue inputs as well. The digital output signal can be
clocked with the following clock frequencies:
INTERNAL
locks both the A/D-converters and the digital output with
the internal reference 44,1 or 48 kHz. Digital inputs are
connected via sample rate converter
AES INPUT locks with the clock frequency of the input signal at
digital input CH 1/2 (AES/EBU, 44,1...48 kHz)
EXT AES locks with the AES signal at the sync input
(AES, 44,1...48 kHz) Digital inputs are connected via sample
rate converter
EXT WCLK locks with the word clock signal at the sync input
(WCLK, 44,1...48 kHz) Digital inputs are connected via sample
rate converter
EXT VIDEO locks with black burst at sync input (internal 48 kHz) Digital
inputs are connected via sample rate converter
Important Note!
Video Sync is an option for the d06. For the very rare case
that you can not synchronize the d06 to AES, you may buy such option from
Junger Audio. Pls contact your local dealer for details.
POWER INPUT
IEC mains input connector 85-264V, 50/60 Hz with integrated fuse
REMOTE
serial remote interface RS-422 (232)
connector: 9pin SUB-D, female
GPI
parallel remote interface
TALLY-out open relay contact
connector: 25pin SUB-D, female
GPI-in optical coupler +3,5…+30V
connector: 15pin SUB-D, female
3.6
SYNCHRONIZING
THE DIGITAL
OUTPUT
3.7
REAR PANEL
CONNECTORS
DIGITAL
I/O ANALOGUE
I/O
SYNC IN
WCLK OUT
LAN-controller
web interface
SERIAL
REMOTE
GPI REMOTE
IN/OUT