Junger Audio J*AM Application Manager - Manual (Page 5)

J*AM
2
Device/Proc Name for each device you will read the URL [e.g. "http://10.110.64.128] and the
device name [e.g. "Loudness Processor 07"]. You may click on the link to
open a browser that will show the web GUI of the device.
in the case of a c8k system inline with the URL, the display shows the
frame name [e.g. "Junger Loudness Control"] and the processor name
one line below [e.g. "NDR-HH"] and further down the program names
including the channels used by that program, separated by a colon
[e.g. "Program 1:1-6"].
Model[ID]/Status the device model [e.g. "TAP"] or, in the case of a c8k system
the module type and its address [e.g. "C8086+M[1]"] can be read here.
In line with the program names you can see the status [
online / offline ].
Reconnect if the communication between the J*AM and the device or frame is
interrupted you may reconnect with it from here.
Disconnect you may disconnect the communication between the J*AM
and the device or frame.
For the c8k system one must keep in mind that all modules of a c8k frame communicate internally via the
CAN bus but the bandwidth of the CAN bus is limited so you can not gather an unlimited amount of
measurement data. At the moment we have limited the number of c8k processors which may be
connected with the J*AM to 2 at a time.
Below a J*AM GUI that is connected with a T*AP and a c8k frame that has one LevelMagicII ™ processor
C8086+ installed. You must enable the check box beside the c8k processor in order to read measurement
data from that module: