Ivie iFlex 2400 Series - Manual (Page 12)

10
‘ignored’ or not. If the selector is to be used, type in the selector position
number, and click ‘OK’. The selector will show the position number, and
will change to the color green.
Creating
Left-clicking the ‘create’ button in the lower window section of the modes
page will create a new mode. The user is prompted to type in a new name
for the mode, and then set the switches in the upper window to the proper
state for the mode. When all the switches are set the mode should be
saved before creating a new mode.
Other options for working with modes in the list are:
Revert – Discards changes since last save of the highlighted mode.
Delete – Deletes highlighted mode.
Clone – Copies the highlighted mode and adds ‘clone’ to the new name.
Rename – Renames the highlighted mode.
Color is also an important attribute of any mode associated with an output
zone, and can be set with the pull down menu option. Output zones will
change color during system simulation depending on the current mode,
and the color assignments made to the modes in this page.
When the modes for each input and output are fully defined, left-click on
the associations tab to continue.
Associations