ILUMINARC Ilumiline™ 36 IP - Manual (Page 15)

Operation
Ilumiline 36 IP Optic (RGB or VW) User Manual Rev. 6 11
To assign
individual DMX
addresses to
each product,
you must connect the
Ilumicode to each
product, individually.
ILUMINARC®
suggests that you
connect no more
than 20 products
in this mode and keep the
total distance to less than
60 m (197 ft). Otherwise,
you might need to use an
optically isolated signal
amplifier.
Ilumicode
The Ilumiline 36 IP Optic (RGB or VW) uses the Ilumicode for configuration purposes. The
diagram below shows how to connect the Ilumicode to this product. This connection will
control multiple products at the same time, all having the same DMX address.
The Ilumicode must be used to configure this product. The Ilumicode can be purchased
separately through your ILUMINARC® sales representative.