ILUMINARC Ilumiline™ 36 IP - Manual (Page 13)

Operation
Ilumiline 36 IP Optic (RGB or VW) User Manual Rev. 6 9
If you have not
configured the
DMX starting
address and
DMX mode for each
product, they will all use
their default values. This
means that all products
will operate in unison.
Controllers
Each product in the Ilumiline 36 IP Optic Series can operate with a standard DMX controller, or
the Ilumicode addresser. The sections below provide information on how to connect these
products to the corresponding controllers. The instructions to operate these products with each of
the above controllers are in the Operation chapter of this manual.
DMX Controller
The Ilumiline 36 IP Optic (RGB or VW) can work with a standard DMX controller. The
channel assignments will depend on the chosen personality (see the corresponding Menu Map
on pages 13 and 14) and the DMX address assigned to each product (see Programming on
page 14).
The figure below illustrates how to connect the DMX controller to the Ilumiline 36 IP Optic
(RGB or VW).