CIRCUTOR CEM-C30 series - Manual (Page 11)

3.5.- CONNECTIONS
The CEM-C30 has terminal covers to cover the top of the terminal box and the fixing screws
( Figure 3 ).
Figure 3: Terminal covers of the CEM-C30�
The fixing screws are of the mixed type, allowing the use of PZ2 and flat head screwdrivers.
Table 4:CEM-C30 connections�
Connections
Measurement terminals ( 1, 2, 3, 4, 5, 6, 7, 8, 9, 11)
Maximum cable cross-section
16 mm 2 ( 10 mm 2 with end sleeve ) ≤ 1.2 Nm
Screwdrivers head PZ2
Impulse output terminals ( 21, 22 ) and Power supply ( 13, 14)
Maximum cable cross-section
1.5 mm 2 ( 1.5 mm 2 with end sleeve ) ≤ 0.6 Nm
Screwdrivers head flat head ( 3 x 0.5 mm)
Once connected, the unit can be protected with two connection seals ( Figure 4 ).
Figure 4: Seal of the CEM-C30�
11 Instruction Manual
CEM-C30